Table of Contents
Advertisement
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3)
Press as to select [RESPONSE(ID ALL)].
4)
Press qw to switch the item.
[ON]
[OFF]
5)
Press as to select [GROUP].
6)
Press qw to switch the item.
[A] - [Z]
7)
Press as to select [RESPONSE(ID GROUP)].
8)
Press qw to switch the item.
[ON]
[OFF]
Note
f When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for "NO
SIGNAL SLEEP" of the DIGITAL LINK output supported device should be set to "OFF" to avoid interruption of communication.
f When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps and the parity is fixed to "NONE".
[REMOTE2 MODE]
Set the <REMOTE 2 IN> terminal.
1)
Press as to select [REMOTE2 MODE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f Proceed to Step 3) when [USER] is selected.
3)
Press the <ENTER> button.
4)
Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1)
Press as to select [FUNCTION BUTTON].
2)
Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3)
Press as to select a function.
[DISABLE]
[P IN P]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Returns the response when an ID is designated as ALL.
Does not return the response when an ID is designated as ALL.
Controls multiple projectors simultaneously by sending the ID of RS-232C. You can set groups from
[A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
Returns the response when an ID is designated as GROUP.
Does not return the response when an ID is designated as GROUP.
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (x page 197)
Changes the setting of the <REMOTE 2 IN> terminal.
Disables the <FUNCTION> button.
Switches the [P IN P] setting ([OFF], [USER1], [USER2], or [USER3]). (x page 141)
Displays the sub memory list. (x page 146)
Switches the [SYSTEM SELECTOR] setting. (x page 87)
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 85)
Freezes the image temporarily. (x page 116)
ENGLISH - 137
Advertisement
Table of Contents
