Table of Contents
Advertisement
3)
Enter a security password and press the <ENTER> button.
4)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The projector enters the standby mode to reflect the setting values when [LOAD ALL USER DATA] is executed.
f Data registered from a computer is not included in [ALL USER DATA].
[INITIALIZE]
Return various setting values to their factory default settings.
1)
Press as to select [INITIALIZE].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
f The [INITIALIZE] screen is displayed.
4)
Press as to select an item to initialize.
[ALL USER DATA]
[REGISTERED SIGNAL]
[NETWORK/E-MAIL]
[LOGO IMAGE]
5)
Press the <ENTER> button.
6)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The following settings are not initialized even if [ALL USER DATA] is executed.
g The [DISPLAY OPTION] menu → [UNIFORMITY]
g The [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE]
g The [PROJECTOR SETUP] menu → [OPERATION SETTING] → [MAX LIGHT OUTPUT LEVEL]
g The [PROJECTOR SETUP] menu → [STANDBY MODE]
[SERVICE PASSWORD]
This function is used by a service person.
140 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Returns all setting values including [REGISTERED SIGNAL], [NETWORK/E-MAIL], and [LOGO
IMAGE] to the factory default settings.
The projector enters the standby mode to reflect the setting values.
Deletes all the setting values saved for each input signal.
To delete only a part of a registered signal, perform the procedure described in "Deleting the
registered signal" (x page 144).
Returns the setting of the [NETWORK] menu → [NETWORK SETUP] and the setting of "[E-mail set
up] page" (x page 168) in the web control screen to the factory default settings.
Deletes the image registered in [USER LOGO].
Advertisement
Table of Contents
