Table of Contents
Advertisement
f Proceed to Step 7) when [PC] is selected.
5)
Press as to select [LINK].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[GROUP A]
[GROUP B]
[GROUP C]
[GROUP D]
7)
Press as to select [CALIBRATION TIME].
8)
Press the <ENTER> button.
f The projector will go into the adjustment mode (the time is blinking).
9)
Press qw to select "hour" or "minute", and press as or the number (<0> - <9>) buttons to set a
time.
f Selecting "hour" allows setting of only the hour in increments of one hour, and selecting "minute" allows
setting of only the minute in increments of one minute between 00 and 59.
f When the time is not specified, select [OFF] between 23 and 00 of the hour, or between 59 and 00 of the
minute.
10) Press the <ENTER> button.
f [CALIBRATION TIME] is set.
f Brightness and color are measured at the specified time. The dynamic contrast function does not operate
during measurement.
11) Press as to select [CALIBRATION MESSAGE].
12) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
13) Press as to select [APPLY].
14) Press the <ENTER> button.
f When [CONSTANT MODE] in [BRIGHTNESS CONTROL SETUP] is set to anything other than [OFF], the
brightness and white balance of light source at the time when the <ENTER> button is pressed is recorded
as the standard brightness and white balance.
f If the <ENTER> button is pressed when [LINK] is set from [GROUP A] to [GROUP D], the group name is
displayed on the screens of projectors that have been set in the same group.
15) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f When the projector operates with [CONSTANT MODE] in [BRIGHTNESS CONTROL SETUP] set to [AUTO] or [PC], keep the shutter
function disabled (shutter: open) for at least two minutes, since the brightness sensor calibration is performed after the [BRIGHTNESS
CONTROL SETUP] setting has been completed.
f If the shutter function is enabled (shutter: closed) within approximately 10 minutes after the light source has turned on while [CONSTANT
MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] or [PC], brightness and color cannot be measured. Therefore, brightness
may be corrected approximately two minutes after the shutter function is disabled (shutter: open).
f Since the brightness and the color of the light source do not stabilize for approximately eight minutes after turning on the light source when
the projector operates with [CONSTANT MODE] in [BRIGHTNESS CONTROL SETUP] set to [AUTO] or [PC], the brightness and the color
of the light source will be automatically measured approximately eight minutes after the light source is turned on. A correction is made based
on this measurement result so that the brightness and the color will be the same as the standard brightness and color when adjusted with
the brightness control.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Performs correction by the brightness sensor on one projector without synchronizing with the other
projectors.
The duration that the constant brightness is kept will become longer by setting the value of [LIGHT
OUTPUT] smaller.
Performs correction by the brightness sensor in multiple projectors in synchronization.
Up to four groups (A to D) can be set within the same subnet by using the network function.
Up to eight projectors can be registered and synchronized in one group.
Displays message during calibration.
Does not display messages during calibration.
LINK
GROUP A
ENGLISH - 123
Advertisement
Table of Contents
