Table of Contents
Advertisement
[OPERATION SETTING]
Set the operation method of the projector.
The settings are reflected when "Initial setting (operation setting)" (x page 60) in the [INITIAL SETTING]
screen is already set.
If you change the settings while using the projector, the duration until the luminance of light source decreases by
half may shorten or the luminance may decrease.
Setting [OPERATING MODE]
1)
Press as to select [OPERATION SETTING].
2)
Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3)
Press as to select [OPERATING MODE].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
f Set [OPERATING MODE] to [NORMAL], [USER1], [USER2], or [USER3] when using the projector at an
altitude of 2 700 m (8 858') or higher above sea level.
[NORMAL]
*1
[ECO]
*1
[QUIET1]
*1
[QUIET2]
*1
[LONG LIFE1]
*1
[LONG LIFE2]
*1
[LONG LIFE3]
*1
[USER1]
[USER2]
[USER3]
*1 The runtime is an estimation when the [PICTURE] menu → [DYNAMIC CONTRAST] is set to [3].
5)
Press as to select [APPLY].
6)
Press the <ENTER> button.
7)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The [OPERATING MODE] setting does not return to factory default setting even if the [PROJECTOR SETUP] menu → [INITIALIZE] → [ALL
USER DATA] is executed.
f If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
Setting [MAX LIGHT OUTPUT LEVEL]
Adjust the maximum level to correct screen brightness according to the changes in brightness of the light source.
1)
Press as to select [OPERATION SETTING].
2)
Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3)
Press as to select [MAX LIGHT OUTPUT LEVEL].
4)
Press qw to adjust
120 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Set this item when high luminance is required. The estimated runtime is approximately 20 000 hours.
The luminance will decrease compared to [NORMAL], but set this item to increase the expected life of
the light source. The estimated runtime is approximately 24 000 hours.
The luminance will decrease compared to [NORMAL], but select this item when operation with low
noise is prioritized. The estimated runtime is approximately 20 000 hours.
The luminance will decrease compared to [QUIET1], but select this item when operating the projector
with less noise. The estimated runtime is approximately 20 000 hours.
The luminance will decrease compared to [ECO], butset this item to increase the expected life of the
light source. The estimated runtime is approximately 43 000 hours.
The luminance will decrease compared to [LONG LIFE1], but set this item to increase the expected
life of the light source. The estimated runtime is approximately 61 000 hours.
The luminance will decrease compared to [LONG LIFE2], but set this item to increase the expected
life of the light source. The estimated runtime is approximately 87 000 hours.
[MAX LIGHT OUTPUT LEVEL] and [LIGHT OUTPUT] can be set individually.
Advertisement
Table of Contents
