Table of Contents
Advertisement
rCautions when setting up the projector
f The projector can be used by installing its top placed on the floor. To prevent the top surface from getting
scratched during use, it is recommended to attach about a 20 mm (25/32") square buffer material (such as
rubber cushion) on the four corners of the top surface.
Buffer material
f Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f When installing the projector with a method other than the floor installation using the adjustable feet, top placed
on the floor, or the ceiling installation with the Ceiling Mount Bracket, use the five screw holes for ceiling mount
(as shown in the figure) to fix the projector to the mount.
In such case, make sure that there is no clearance between the screw holes for ceiling mount on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
f Use a torque screwdriver or Allen torque wrench to tighten the fixing screws to their specified tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
(Screw diameter: M6, tapping depth inside the projector: 12 mm (15/32"), torque: 4 ± 0.5 N·m)
f Do not stack projectors on top of each other.
f Do not block the ventilation ports (intake and exhaust) of the projector.
22 - ENGLISH
Chapter 1 Preparation — Precautions for use
Screw holes for ceiling mount (M6)
Adjustable feet
Positions of screw holes for ceiling mount and adjustable feet
Buffer material
Adjustable feet
Floor
Advertisement
Table of Contents
