Table of Contents
Advertisement
[WAVEFORM MONITOR]
[ASPECT]
[PROJECTION METHOD]
4)
Press the <ENTER> button.
[LENS CALIBRATION]
Detect the lens shift limit value of the projector and set the home position and the ET-DLE030, ET-DLE035 lens
standard position automatically.
1)
Press as to select [LENS CALIBRATION].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[DLE030]
3)
Press the <ENTER> button.
f The confirmation screen is displayed.
4)
Press qw to select [OK], and press the <ENTER> button.
f To cancel, select [CANCEL].
f The lens moves up, down, left, and right to detect the lens shift limit value, and automatically set the home
position and the ET-DLE030, ET-DLE035 lens standard position.
f The lens stops to complete the calibration.
Note
f [PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.
f When lens calibration executes correctly, [COMPLETE] is displayed and [INCOMPLETE] is displayed when it does not execute correctly.
f Pressing the <FOCUS> button on the remote control for at least three seconds will also display the confirmation screen for lens calibration
execution.
f The home position is an origin position of the lens shift (vertical position and horizontal position of the lens) based on the calibration result. It
does not match with the optical image center position.
[STATUS]
Display the status of the projector.
1)
Press as to select [STATUS].
2)
Press the <ENTER> button.
f The [STATUS] screen is displayed.
3)
Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE]
[PROJECTOR RUNTIME]
[LIGHT RUNTIME]
[MAIN/SUB VERSION]
[INTAKE AIR TEMP.]
[OPTICS MODULE TEMP.]
[EXHAUST AIR TEMP.]
[LIGHT1 TEMP.]
*1
[LIGHT2 TEMP.]
*1
[COOLING CONDITION]
[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.
[SELF TEST]
[INPUT]
138 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Displays the waveform of the input signal. (x page 116)
Switches the aspect ratio of the image. (x page 89)
Switches the [PROJECTION METHOD] setting. (x page 119)
Select this item when anything other than the Fixed-focus Lens (Model No.: ET-DLE030, ET-DLE035)
is used.
Move the lens to the home position after completing the calibration.
Select this item when the Fixed-focus Lens (Model No.: ET-DLE030, ET-DLE035) is used.
Move the lens to the ET-DLE030, ET-DLE035 lens standard position after completing the calibration.
Displays the projector type and serial number of the projector.
Displays the runtime of the projector.
Displays the runtime of the light source 1 and the light source 2.
Displays the main and sub versions of the firmware of the projector.
Displays the status of the intake air temperature of the projector.
*1
Displays the status of the internal temperature of the projector.
*1
Displays the status of the exhaust air temperature of the projector.
*1
Displays the light source 1 temperature status of the projector.
Displays the light source 2 temperature status of the projector.
Displays the set cooling conditions.
Displays the status of the projector.
Displays the input terminal currently selected.
Advertisement
Table of Contents
