Table of Contents
Advertisement
[NETWORK SETUP]
Perform the initial setting of the network before using the network function.
1)
Press as to select [NETWORK SETUP].
2)
Press the <ENTER> button.
f The [NETWORK SETUP] screen is displayed.
3)
Press as to select an item, and change the settings according to the operation instructions of the
menu.
[PROJECTOR NAME]
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
4)
Press as to select [STORE], and press the <ENTER> button.
5)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f When using a DHCP server, confirm that the DHCP server is running.
f Consult your network administrator regarding the IP address, subnet mask, and default gateway.
f [NETWORK SETUP] cannot be selected when the [NETWORK] menu → [Art-Net SETUP] is set to [ON(2.X.X.X)] or [ON(10.X.X.X)].
[NETWORK CONTROL]
Set up the control method of the network.
1)
Press as to select [NETWORK CONTROL].
2)
Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3)
Press as to select an item, and press qw to change the setting.
[WEB CONTROL]
[PJLink CONTROL]
[COMMAND CONTROL]
[COMMAND PORT]
[Crestron Connected(TM)]
[AMX D.D.]
[EXTRON XTP]
4)
Press as to select [STORE], and press the <ENTER> button.
5)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
152 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
Allows to change the projector name. Enter the host name if it is required to use a DHCP server.
[ON]
[OFF]
Enter the IP address when a DHCP server is not used.
Enter the subnet mask when a DHCP server is not used.
Enter the default gateway address when a DHCP server is not used.
Set to [ON] to control with the web browser.
Set to [ON] to control with the PJLink protocol.
Set to [ON] to control with the <SERIAL/MULTI PROJECTOR SYNC IN>/<SERIAL/MULTI
PROJECTOR SYNC OUT> terminal control command format (x page 196). Refer to "Control
commands via LAN" (x page 190).
Set the port number used for command control.
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through "AMX Device Discovery". For details, visit the
website of AMX Corporation.
URL http://www.amx.com/
Set to [ON] when connecting the "XTP transmitter" of Extron Electronics to the <DIGITAL LINK/LAN>
terminal.
Set to [OFF] when connecting the optional DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G).
For details of the "XTP transmitter", visit the website of Extron Electronics.
URL http://www.extron.com/
If a DHCP server exists in the network where the projector is to be
connected, obtains the IP address automatically.
If a DHCP server does not exist in the network where the projector
is to be connected, set [IP ADDRESS], [SUBNET MASK], and
[DEFAULT GATEWAY].
Advertisement
Table of Contents
