Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
For other countries or regions
1)
Confirm that the <MAIN POWER> switch on the side of the projector is on the <OFF> side, and
remove the power plug from the outlet.
2)
Remove the power cord connector from the <AC IN> terminal of the projector while pressing the side
tabs.
Attention
f Do not remove the connector while the ends of the side tabs of the connector are hooked in the tabs of the <AC IN> terminal. If the
connector is removed while the tabs are hooked, the ends of the tabs may become damaged. Please stop using the projector if the tabs are
broken, and consult your dealer.
Power indicator
Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating
the projector.
Indicator status
Off
Red
Green
Orange
Note
f While the power indicator <ON (G)/STANDBY (R)> lights in orange, the fan is running to cool the projector.
f For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks in red.
Power indicator <ON (G)/STANDBY (R)>
The main power is switched off.
The power is switched off. (standby mode)
Projection will start when the power on <b> button is pressed.
f The setting of the projector is as follows.
Lit
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [OFF].
f The projector may not operate when the light source indicators <LIGHT1>/<LIGHT2>
or the temperature indicator <TEMP> are blinking. (x page 177)
The power is switched off. (standby mode)
Projection will start when the power on <b> button is pressed.
f The setting of the projector is as follows.
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
f The indicator will change to a red light when the specified time has elapsed after the
projector enters the standby mode if the projector is set as following.
Blinking
The specified time is the time set in the [PROJECTOR SETUP] menu → [QUICK
STARTUP] → [VALID PERIOD].
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
f The projector may not operate when the light source indicators <LIGHT1>/<LIGHT2>
or the temperature indicator <TEMP> are blinking. (x page 177)
Lit
Projecting.
The projector is preparing to switch off the projector.
Lit
The power is switched off after a while. (Changes to the standby mode.)
Projector status
ENGLISH - 57
Advertisement
Table of Contents
