Locator Screen - ZyXEL Communications WAC6000 Series Manual

Figure 105 Maintenance > LEDs > Suppression
The following table describes fields in the above screen.
Table 83 Maintenance > LED > Suppression
LABEL
Suppression On
Apply
Reset

16.3 Locator Screen

The Locator feature identifies the location of your WAC among several devices in the network. You
can run this feature and set a timer in this screen.
To run the locator feature, enter a number of minutes and click Turn On button to have the WAC
find its location. The Locator LED will start to blink for the number of minutes set in the Locator
screen. The default setting is 10 minutes. While the locator is running, the turn on button will grey
out and return after it's finished. If you make changes to the time default setting, it will be stored
as the defualt when the WAC restarts.
Note: The Locator feature is not affected by the Suppression setting.
To access this screen, click Maintenance > LEDs > Locator.
Chapter 16 LEDs
DESCRIPTION
If the Suppression On check box is checked, the LEDs of your NWA/WAC will turn
off after it's ready.
If the check box is unchecked, the LEDs will stay lit after the NWA/WAC is ready.
Click Apply to save your changes back to the NWA/WAC.
Click Reset to return the screen to its last-saved settings.
NWA5000 / WAC6000 Series User's Guide
181