Locator Screen - ZyXEL Communications NWA Series User Manual

Figure 153 Maintenance > LEDs > Suppression
The following table describes fields in the above screen.
Table 103 Maintenance > LED > Suppression
LABEL
Suppression On
Apply
Reset

21.3 Locator Screen

The Locator feature identifies the location of your Zyxel Device among several devices in the network.
You can run this feature and set a timer in this screen.
To run the locator feature, enter a number of minutes and click Turn On button to have the Zyxel Device
find its location. The Locator LED will start to blink for the number of minutes set in the Locator screen. The
default setting is 10 minutes. While the locator is running, the turn on button will gray out and return after
it's finished. If you make changes to the time default setting, it will be stored as the default when the
Zyxel Device restarts.
Note: The Locator feature is not affected by the Suppression setting.
To access this screen, click Maintenance > LEDs > Locator.
Chapter 21 LEDs
DESCRIPTION
If the Suppression On check box is checked, the LEDs of your Zyxel Device will turn off after
it's ready.
If the check box is unchecked, the LEDs will stay lit after the Zyxel Device is ready.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
NWA/WAC/WAX Series User's Guide
247