Nwa5301-Nj Hardware; Punch-Down Block - ZyXEL Communications WAC6000 Series Manual

1.5 NWA5301-NJ Hardware

1.5.1 110 Punch-Down Block

This section shows you how to use a punch-down tool to seat an 8-wire Ethernet cable to the 110
punch-down block. You can connect a PoE switch to the 110 punch-down block to provide power
and Internet access to the NWA through this connection. An 8-pin Ethernet cable has four pairs of
color coded wires.
Cut out one and a half inches of the jacket from the Ethernet cable to expose the wires.
1
Untwist the wire pairs no more than one inch.
2
Match each wire to the correct slot according to the color codes for wiring shown below.
3
NWA Rear Panel
PIN#
Table 4 Color Codes for 110 Punch Down Block Wiring
PIN#
1
2
3
4
5
6
7
8
Use a punch-down tool to seat the wires down properly into the slot.
4
Chapter 1 Introduction
UPLINK
PHONE
PORT
PORT
WIRE COLOR
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
NWA5000 / WAC6000 Series User's Guide
18