Cpu Usage - ZyXEL Communications WAC6000 Series Manual

Table 19 Dashboard (continued)
LABEL
Action
WLAN Interface
Status Summary
Status
MAC Address
Radio
Band
OP Mode
Channel
Antenna
Station
AP Information
All Sensed Device
Un-Classified AP
Rogue AP
Friendly AP

3.2.1 CPU Usage

Use this screen to look at a chart of the NWA/WAC's recent CPU usage. To access this screen, click
CPU Usage in the dashboard.
Figure 19 Dashboard > CPU Usage
Chapter 3 Dashboard
DESCRIPTION
If the interface has a static IP address, this shows n/a.
If the interface has a dynamic IP address, use this field to get or to update the IP
address for the interface. Click Renew to send a new DHCP request to a DHCP server.
This displays status information for the WLAN interface.
This displays whether or not the WLAN interface is activated.
This displays the MAC address of the radio.
This indicates the radio number on the NWA/WAC.
This indicates the wireless frequency band currently being used by the radio.
This shows - when the radio is in monitor mode.
This indicates the radio's operating mode. Operating modes are AP (MBSSID), MON
(monitor), Root AP or Repeater.
This indicates the channel number the radio is using.
This indicates the antenna orientation for the radio (Wall or Ceiling).
This field is not available if the NWA/WAC does not allow you to adjust antenna
orientation for each radio using the web configurator or a physical switch. Refer to
1 on page 11 and Table 2 on page 11
This displays the number of wireless clients connected to the NWA/WAC.
This shows a summary of connected wireless Access Points (APs).
This sections displays a summary of all wireless devices detected by the network. Click
the link to go to the Monitor > Wireless > Detected Device screen.
This displays the number of detected unclassified APs.
This displays the number of detected rogue APs.
This displays the number of detected friendly APs.
NWA5000 / WAC6000 Series User's Guide
45
to see if your NWA/WAC has an antenna switch.
Table