Network Specifications - Epson L5290 Series User Manual

Product Information
Resolution
Page Memory
*
Redial
Interface
* The specifications may differ by country or region.

Network Specifications

Wi-Fi Specifications
Standards
Frequency Range
Coordination Modes
*4
Wireless Securities
*1 IEEE802.11n is only available for the HT20.
*2 Not supported for IEEE 802.11b.
*3 Simple AP mode is compatible with a Wi-Fi connection (infrastructure) or an Ethernet connection.
*4 Wi-Fi Direct supports WPA2-PSK (AES) only.
*5 Complies with WPA2 standards with support for WPA/WPA2 Personal.
Ethernet Specifications
ET-4800 Series/L5290 Series Only
Standards
Communication Mode
Connector
*1 Use a category 5e or higher STP (Shielded twisted pair) cable to prevent risk of radio interference.
> >
Product Specifications
Monochrome
❏ Standard: 8 pel/mm×3.85 line/mm (203 pel/in.×98 line/in.)
❏ Fine: 8 pel/mm×7.7 line/mm (203 pel/in.×196 line/in.)
❏ Photo: 8 pel/mm×7.7 line/mm (203 pel/in.×196 line/in.)
Color
200×200 dpi
Up to 100 pages (when received ITU-T No.1 chart in monochrome draft mode)
2 times (with 1 minute intervals)
RJ-11 Phone Line, RJ-11 Telephone set connection
IEEE802.11b/g/n
2.4 GHz
Infrastructure, Wi-Fi Direct (Simple AP)
WEP (64/128bit), WPA2-PSK (AES)
Network Specifications
*1
*2*3
*5
, WPA3-SAE (AES)
*1
IEEE802.3i (10BASE-T)
IEEE802.3u (100BASE-TX)
IEEE802.3az (Energy Efficient Ethernet)
Auto, 10Mbps Full duplex, 10Mbps Half duplex, 100Mbps
Full duplex, 100Mbps Half duplex
RJ-45
271
*2*3