Epson L375 Start Here

L375
Start Here
Read these instructions before using your product.
1
Unpack
Note: Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective materials
from inside the product.
Caution: Do not touch the flat white cable or the ink tubes and
their translucent cover.
3
Lower the scanner unit.
2
Fill ink tanks
Note: This product requires careful handling of ink. Wear disposable
gloves and place a sheet of paper under the ink tank unit when you
fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Caution: Keep the ink bottles out of the reach of children and do not
drink the ink.
1
Open the ink tank unit cover, then remove the cap for the
cyan ink tank and attach it to its holder.
2
Unpack the cyan ink bottle.
3
Snap the bottle tip off, then remove the bottle cap.
Carefully remove the protective seal (avoid touching the ink
underneath the seal), then close the bottle cap tightly.
Caution: Be sure to close the bottle cap tightly, or ink may leak.
4
Fill the tank using all of the ink in the bottle.
Note: Refer to the color coded sticker on the ink tank unit cover
to identify the color of each tank.
Caution: Be sure to fill each tank with the correct ink color.
5
Carefully seal the bottle using the reverse side of the bottle
tip for proper disposal.
6
Replace the ink tank cap securely.