Table of Contents
Advertisement
The protocol-dependent configuration will be covered in subsequent chapters.
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up
Internet access, you are actually configuring a remote node.
5.1
Remote Node Setup
This section describes the protocol-independent parameters for a remote node. Menu 4 (discussed
previously – see Figure 4-4) is actually a simplified setup for the remote node that you can access in Menu
11.
5.1.1 Remote Node Profile
To configure a remote node, do the following:
From the Main Menu, select menu option 11. Remote Node Setup.
When Menu 11.1 - Remote Node Profile appears fill in the fields as described in the table that follows to
define this remote profile. The Remote Node Profile Menu Fields table (
Table 5-1) shows you how to configure the Remote Node Menu (Figure 5-1).
5.2
Encapsulation
Please see section 4.6 for more details on encapsulation.
Note: You must restart the P681 when you change the Encapsulation method in Menu 4 or
Menu 11.1.
Remote Node Configuration
Remote Node Configuration
In this chapter, we discuss the parameters that are protocol independent.
Prestige 681 SDSL Router
Chapter 5:
5-1
Advertisement
Table of Contents
Troubleshooting
