ZyXEL Communications Prestige 681 User Manual page 73

Table 6-1
Field Description
Route Make sure IP is among the protocols in the [Route] field in
Menu 11.1 - Remote Node Profile.
Rem IP Address Enter the IP address of the remote gateway in Menu 11.1 -
Remote Node Profile. You must fill in either the remote
Prestige WAN IP address or the remote Prestige LAN IP
address. This depends on the remote router's WAN IP i.e., for
the (remote) Prestige, the My WAN Addr settings in Menu
11.3 – Remote Node Network Layer Options. For example
(see
(the remote router's WAN IP), then you should enter
172.16.0.2 in the Rem IP Address field. If the remote WAN IP
is 0.0.0.0, then enter 192.168.1.1(the remote router's LAN IP)
in the Rem IP Address field).
Edit IP Press the [SPACE BAR] to toggle this field to Yes and then
press [ENTER] to go to Menu 11.3 - Remote Node Network
Layer Options menu.
The following table shows the TCP/IP related fields in Menu 11.3 - Remote Node Network Layer
Options.
Table 6-2
Field Description
Rem IP Address This will show the IP address you entered for this remote node in
the previous menu.
Rem IP Subnet Enter the subnet mask for the remote network.
Mask
My WAN Addr Some implementations, especially the UNIX derivatives, require
the WAN link to have a separate IP network number from the
LAN and each end must have a unique address within the WAN
network number. If this is the case, enter the IP address assigned
to the WAN port of your Prestige.
Note that this is the address assigned to your local Prestige
WAN, not the remote router. If the remote router is a Prestige,
then this entry determines the local Prestige Rem IP Address in
menu 11.1 (see
Single User Set this field to Yes to enable the Single User Account feature for
your Prestige. Use the [SPACE BAR] to toggle between Yes and
Account
No. See Chapter 4: Internet Access for more information on the
Remote Node TCP/IP Configuration
Prestige 681 SDSL Router
TCP/IP related fields in Menu 11.1 - Remote Node Profile
Figure 6-3 ), if the remote WAN IP is set to 172.16.0.2
TCP/IP Remote Node Configuration
Table 6-1
above).
Option
IP
Yes
(Yes/No)
Option
Yes/No
6-3