Remote Node Bridging Setup; Table 8-2 P681 Remote Node Network Layer Menu Bridge Options - ZyXEL Communications Prestige 681 User Manual

8.2.1 Remote Node Bridging Setup

Follow the procedure in Chapter 5: to configure the protocol-independent parameters in Menu 11.1 -
Remote Node Profile. For bridging-specific parameters, you need to configure Menu 11.3 - Remote Node
Network Layer Options.
To set up Menu 11.3 - Remote Node Network Layer Options follow these steps:
Step 1. In Menu 11.1, make sure the Bridge field is set to Yes.
Step 2. Move the cursor to the Edit IP/IPX/Bridge field, then press the [SPACE BAR] to toggle this
field to Yes and press [ENTER] to open Menu 11.3 - Network Layer Options.
Frame Relay Parameters :
DLCI= 16
IP Options :
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= No
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Figure 8-2
The following table describes the bridging-specific parameters in Menu 11.1 - Remote Node Profile and
Menu 11.3 - Remote Node Network Layer Options.
Table 8-2
Field Description
Bridge (menu 11.1) Make sure this field is set to Yes.
Edit IP/IPX/Bridge Press the [SPACE BAR] to change the default to Yes and then press
(menu 11.1) [ENTER] to go to Menu 11.3 - Network Layer Options.
Ethernet Addr In this field, enter the time (number of minutes) that you wish your
Timeout (min) (menu Prestige 681 to retain the Ethernet Addr information in its internal tables
11.3) while the line is down. If this information is retained, your Prestige 681
will not have to recompile the tables when the line is brought back up.
Bridging Setup
Prestige 681 SDSL Router
Menu 11.3 - Remote Node Network Layer Options
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.3 - Remote Node Bridging Options
P681 Remote Node Network Layer Menu Bridge Options
IPX Options :
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
Bridge Options:
Ethernet Addr Timeout(min)= 0
8-3