Outgoing Authentication Protocol; Editing Ppp Options - ZyXEL Communications Prestige 681 User Manual

Prestige 681 SDSL Router
Field
Edit PPP Options
Rem IP Addr
Edit IP/IPX/Bridge
Session Option:
Edit Filter Sets
Once you have completed filling in Menu 11.1 – Remote Node Profile, press [ENTER] at the message
[Press ENTER to Confirm...] to save your configuration, or press [Esc] at any time to cancel.

5.2.1 Outgoing Authentication Protocol

Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons.
However, some vendor's implementation includes specific authentication protocol in the user profile. It
will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If you encounter the case where the peer disconnects right after a
successful authentication, please make sure that you specify the correct authentication protocol when
connecting to such an implementation.

5.2.2 Editing PPP Options

To edit the remote node PPP Options, move the cursor to the Edit PPP Options field in Menu 11.1 -
Remote Node Profile, and use the [SPACE BAR] to toggle this field to Yes. Press [ENTER] to open
Menu 11.2, as shown next.
5-4
Description
otherwise, the packets are discarded. .
To edit the PPP options for this remote node,
move the cursor to this field, use the [SPACE
BAR] to select Yes and press [ENTER]. This
will bring you to Menu 11.2 - Remote Node
PPP Options. For more information on
configuring PPP options, see section 5.2.2
Editing PPP Options.
Enter the IP address of the remote gateway
here. If you don't know this IP, then enter
0.0.0.0 .
Press the [SPACE BAR] to toggle this field to
Yes and then press [ENTER] to go to Menu
11.3 - Remote Node Network Layer Options
menu.
Use the [SPACE BAR] to toggle this field to
Yes and press [ENTER] to open Menu 11.5 to
edit the filter sets. See the Remote Node Filter
section for more details.
Options
Press [SPACE BAR] to
toggle to Yes and then
press [ENTER]
Yes or No
Default= No
Remote Node Configuration