2.1
Front Panel LEDs OF P681
The LED indicators on the front panel indicate the operational status of the Prestige 681. The table below
the diagram describes the LED functions:
PWR
The PWR (power) LED is on when power is applied to the Prestige.
SYS
A steady on SYS (system) LED indicates the Prestige is on and functioning properly
while an off SYS LED indicates the system is not ready or a malfunction. The
system is rebooting when the SYS LED is blinking.
A steady green light indicates a 10Mb Ethernet connection. The LED blinks when
LAN 10M
data is being sent/received.
A steady green light indicates a 100Mb Ethernet connection. The LED blinks when
LAN 100M
data is being sent/received.
SDSL
The SDSL LED is on when the Prestige is connected successfully to a DSLAM. The
LED blinks when the link is still synchronizing – note that this may take up to 10
minutes.
2.2
Prestige 681 Rear Panel and Connections
The following figure shows the rear panel connections of your Prestige.
Installation & Setup
Prestige 681 SDSL Router
Hardware Installation & Initial Setup
This chapter describes the physical features of the
Prestige and how to make the cable connections
Figure 2-1
Prestige 681 Front Panel.
Table 2-1
Front Panel LED Description
Chapter 2:
.
2-1