CDA HC9626FR Directions For Installation, Use And Maintenance page 19

Problem
Residual heat indicator
has extinguished despite
zone(s) still being hot.
One or more heating
elements (glowing red
area) is switching on and
off periodically, producing a
click when doing so.
Hob top is broken, cracked
and/or chipped.
A fault has not been
resolved by any suggested
remedies or a fault code is
displayed
Should any error code show on the zone displays, or the above
steps not resolve an issue, please contact CDA Customer Care for
assistance. Contact details are on page 17.
IMPORTANT - PLEASE NOTE: In the event of any breakage, crack
or cracking – even minimal – of the vitroceramic glass, immediately
disconnect your appliance to prevent a risk of electric shock and
contact CDA Customer Care.
Possible Causes
The appliance has no
power or the zone
temperature is lower than
the sensor can regsiter.
This 'cyclic' function
is normal for this hob.
Ceramic zones produce
high heat levels and as
such cycle on and off,
particularly on lower heat
settings.
Stop using the appliance immediately and switch the
appliance off at the mains. Contact CDA Customer
Care to arrange a repair (contact details on page 17).
Contact CDA Customer Care using the contact details
on page 17 to arrange a service visit.
Possible Remedy
Check the fuse and
replace if blown.
No action needed.
19