Table of Contents
Advertisement
Copying
Programming Defaults in Initial Display
This section describes how to program defaults for the initial display when
modes are cleared or reset, or immediately after the operation switch is turned.
The default settings you can program are Paper Tray, Original Type, Density,
Special Original, Original Orientation, Cover/Slip Sheet, Dup./Combine/Se-
ries, Reduce / Enlarge, Finishing.
2
A
Specify scan settings and any other settings you require in the initial display.
B
Press the {Program} key.
C
Press [Program as Defaults].
D
Press [Program].
E
Press [Yes].
The current settings are programmed as defaults. The screen returns to the in-
itial display.
Note
❒ To restore the factory default settings on the initial display, press [Restore
Factory Defaults].
❒ The default settings can be programmed separately for the normal screen
and simplified screens.
146
Advertisement
Table of Contents
