Table of Contents
Advertisement
Connection (Continued)
Notes
• When COMPUTER 2 IN terminal (also used for MONITOR OUT terminal) is used as
MONITOR OUT terminal, the signal which is input to COMPUTER 1 IN terminal is output.
• Signals are output from MONITOR OUT terminal even in standby mode.
However, from AUDIO OUT terminal, no audio signal is output.
• A computer monitor cannot accept Y/P
• The AUDIO IN terminal doubles for devices connected to COMPUTER 1 terminal and
COMPUTER 2 terminal.
• When an AUDIO OUT terminal is connected, sound is not output from the projector
speaker.
• Output volume of AUDIO OUT terminal can be adjusted by the VOL button.
• Moving pictures played back on computers using DVD software may appear unnatural
when projected with this projector. However, it is not a malfunction of the projector.
/P
signals correctly.
B
R
22
Operations
Turning the power on and off
■ Connecting the power cord
1
Insert the power cord connector into
the AC IN socket of the projector.
2
Insert the power cord plug into a
wall or other power outlet.
The ON/STANDBY indicator will
change to orange, indicating standby
mode.
■ Removing the lens cover
Be sure to remove the lens cover when the power is
turned on. If the cover is left on the projector, it could
become deformed due to heat.
■ Turning the power on
Press the ON/STANDBY
button.
When the beep sound is [On], the
projector beeps, the power turns on,
and the ON/STANDBY indicator lights
in green. After a moment, the start-up
screen appears.
CAUTION
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyesight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.
• Do not place your hands, face, or other objects near the air exhaust. Doing so could result in
injury and/or damage the object.
Power cord connector
(Supplied)
Remote
Control panel
Control
Start-up screen
23
Advertisement
Table of Contents
