Turning The Power On And Off - Toshiba TDP ET20/U Owner's Manual

Turning the power on and off

■ Connecting the power cord
Insert the power cord connector into
1
the AC IN socket of the projector.
Insert the power cord plug into a wall
2
or other power outlet.
■ Turning the power on
Turn on the main power switch.
1
The blue LED at the Power key will start to
flash, indicating standby mode.
Activate the projector.
2
The projector can be activated by pressing the
Power key on the control panel for 3~5 sec-
onds, or press the ON/Standby button on the
remote control.
When the projector is activated, the red LED
at the Power key starts to light up for seconds
then off, all the blue LED on the control panel
will light up and Start-up screen will display.
WARNING
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes or sight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal
overheating.
• Do not place your hands, face, or any other objects near the air exhaust. Doing so
could cause injury or could deform or break the object.
• Turn off AC switch before plugging out power cable.
26
Power cord
connector