Kurzweil K2700 Musician's Manual page 322

Global Mode
MAIN 2 Page
Switch Pedal Overrides
The Switch Pedal Override parameters (SW1A-SW2B Override) allow the controller
assignments for the Switch Pedals to be changed for all Programs and Multis. (KB3 organ
programs have a separate override for the SW1A pedal, see the Rotary Override section below
for details.) The alternative assignments available for the Switch Pedal Overrides include the
standard pedal controls of Sustain, Sostenuto and Soft as well as Data Inc, Data Dec, Quick
Acc Inc and Quick Acc Dec, which can be used to change Programs, Multis or Quick Access
spots by using a pedal.
Use the Data Inc and Data Dec assignments (data increment/decrement) to select the next
or previous ID when you depress the pedal. If you are in Program mode, Data Inc and Data
Dec will select the next or previous Program. If you are in Multi mode, Data Inc and Data
Dec will select the next or previous Multi.
Use the Quick Acc Inc and Quick Acc Dec assignments (Quick Access increment/
decrement) to select the next or previous Quick Access spot when you depress the pedal. If
you do not have a Quick Access spot selected, Quick Acc Inc and Quick Acc Dec will select
the first Quick Access spot, or the last spot that was selected since turning on the K2700.
Use the Arp On/Off and Arp Latch assignments to easily control arpeggiator functions.
The Arp On/Off assignment allows you to toggle the arpeggiator on and off by pressing
a switch pedal. The Arp Latch assignment allows you to latch held notes to be played by
the arpeggiator by holding down a switch pedal. When using the Arp Latch assignment,
make sure the arpeggiator is turned on. Play the notes you wish to latch, press and hold the
assigned pedal, then release the notes. The notes will continue to arpeggiate until the pedal is
released. (The functionality may differ depending on the current arpeggiator Latch settings,
see Latch on page 3-27 for details.)
In Multi Edit Mode, if a pedal is selected which has a pedal override enabled in Global
mode, a message "Global Pedal Override is enabled" will display when that pedal is viewed to
remind you that the Global mode pedal override settings are being used instead of the Multi
mode pedal settings.
In Multi Edit Mode, setting a Pedal Mode to "Off" will disable the override for that Pedal
in the selected Zone. It can be useful in Multi Mode to disable the Pedal Override for some
Zones. For example, you may want to use a Pedal Override to control Sustain in all Zones of
a Multi, but disable Sustain for one Zone.
When a Pedal Switch Override is used, the pedal will behave in Multi Mode as if the
OnValue and OffValue are set to 127 and 0 respectively (this will not be shown in Multi Edit
Mode). When a Pedal Switch Override is set to Sustain, Sostenuto or Soft, the pedal will
behave in Multi Mode as if Pedal Type is set to Momentary (this will not be shown in Multi
Edit Mode). When set to Data Inc, Data Dec, Quick Acc Inc or Quick Acc Dec the pedal
will behave in Multi Mode as if Pedal Type is set to Toggle (this will not be shown in Multi
Edit Mode).
9-11