Kurzweil K2700 Musician's Manual page 215

Multi Mode
Controllers
Dual Switch Pedals
The SW1 (SUSTAIN) and SW2 jacks can be connected to dual switch pedals (2 pedals per
jack), allowing up to four switch pedals to be used. To emulate the 3 pedals of an acoustic
piano, plug a single switch pedal into the SW1 (SUSTAIN) jack, and a dual switch pedal
into the SW2 jack. For details see Dual Switch Pedals on page 1-12.
Continuous Switch Pedals (Half-Damper)
The SW1 (SUSTAIN) jack is also compatible with continuous switch pedals (Half-Damper)
that use a 1/4 inch tip-ring-sleeve plug (such as the Kurzweil KP-1H). When connected
to the SW1 (SUSTAIN) jack, a Half Damper pedal enables finer control of Sustain than a
standard switch pedal. Half Damper control is enabled for Programs in the Piano category.
Programs outside of the Piano category will respond to a Half Damper pedal as if it is a
standard switch pedal.
CC1 (VOLUME) and CC2 Pedals
The CC1 (VOLUME) pedal defaults to control Program volume (pre-FX).
For KB3 Organ Programs, the CC (VOLUME) pedal controls organ swell. Organ swell is
similar to Program volume, except volume can not be turned all the way down to silence.
The Display shows "KB3" when a Multi containing a KB3 Program is selected.
The CC2 pedal typically controls FX such as wah.
The CC1 (VOLUME) and CC2 pedals can be enabled, disabled, or reassigned for each Zone
in Multi Edit Mode. Because of this, the pedals may function differently for each Zone in
each Multi.
6-7