Kurzweil K2700 Musician's Manual page 217

The Layer Function
When you create a Layer in Multi Mode, you are activating a new Zone in the current Multi.
You can choose a Program that will be used as the new layered Zone.
Follow these steps to create a Layer:
1. In Multi Mode, select a Multi.
2. Press the LAYER soft button.
3. On the "Layer" Page, the new Zone is selected with a default layer Program selected. Use
the ALPHA WHEEL or CATEGORY buttons to select a different Program for the new
layered Zone.
4. You may wish to adjust additional Layer parameters, described in
Parameters on page
5. Press the SAVE button to save your Layer as a Multi (See below for details on saving).
After saving your Layer Multi, you can edit additional Multi parameters in Multi Edit
mode.
Split and Layer Parameters
Zone Status
Selecting Split or Layer makes a new Zone active. You can continue to activate additional
Zones with the Stat parameter.
Program
The Program parameter for the first available Zone determines the Program for the left-hand
side of the Split, also known as the "Split Program". This parameter is selected by default
when performing the Split function, and the default Split Program will be selected. Choose
a Split Program using the CATEGORY buttons, the ALPHA WHEEL, the PREVIOUS/
NEXT buttons, or enable the KEYPAD button and type an ID number followed by the
ENTER button.
Volume
Use the Volume parameter to change the volume of each Zone. To set a volume, use the
Alpha Wheel, the Previous/Next buttons, or use the keypad function of the Category buttons
to type a volume (0-127) followed by the Enter button.
A value of "None" will use the last volume value used by the Zone's MIDI channel (often set
by the expression pedal). A value of "None" can be entered by scrolling below 0, or by using
the keypad function of the Category buttons to type negative 1 by pressing the small +/-
button and then the 1 button, followed by the Enter button.
2-9.
The Split and Layer Soft Buttons
Split and Layer
Multi Mode
6-9