Table of Contents
Advertisement
SYSTEM SETUP
1=TROUBLE REM
2=BANNER
3=TIME-DATE
System Setup Screen #1
MS-9050UD PN 52413:C 01/23/08
These screens allow the programmer to enter a two line custom banner. A flashing cursor will
appear in the bottom left corner of each display. A maximum of 20 characters (including
spaces) can be entered into each screen for a total of two lines with 40 characters. After
entering up to 20 characters in the first screen, press Enter to view the second screen. Enter up
to 20 characters in the second screen in the same manner or just press Enter if a second banner
line is not being entered. To quickly clear the current banner, press the CLR key.
To enter alphanumeric characters from the keypad, repeatedly press the appropriate key until
the desired character is displayed in the first position. For example, to enter the letter B, press
the 2 (ABC) key three times to toggle through the characters 1, A and B. Press the right arrow
key to move the cursor one position to the right and repeat the process to enter the next
character. To enter a space, press the * (QZ) key four times to place a blank in the desired
position. When all characters have been entered, press the Enter key to store the information.
The display will return to the Banner Screen.
3.6.5.3 Time-Date
The control panel time and date can be changed by pressing 3 while viewing the System Setup
Screen #1. The following screen will be displayed:
1=TIME
2=DATE
3=CLOCK FORMAT
1=DAYLIGHT SAVINGS
3.6.5.3.1 Time
To change the time, press 1 while viewing the Time-Date Screen. The following screen will be
displayed:
10:00 AM
1=AM
A flashing cursor is located toward the top left of the display. Below the cursor is the current
time. To change the time, enter the two-digit hours followed by the two-digit minutes. The
cursor will move one position to the right each time a digit is entered. After the last minutes
digit is entered, the cursor will again move one position to the right. At this point enter 1 for
AM or 2 for PM. The display will then return to the Time-Date Screen which will show the
new time entry. If an error is made while entering a digit, press the CLR key to delete the entire
entry and begin again.
TIME AND DATE
10:00 AM
09-07-2009
Time-Date Screen #1
TIME AND DATE
Time-Date Screen #2
ENTER TIME
Time Screen
Programming
12HR
2=PM
91
Advertisement
Table of Contents
