Programming
PROGRAMMING
1=ANN-RLY OPTIONS
2=ANN-LED OPTIONS
ANN-BUS Screen #3
110
ANN-LED Options Screen
Pressing 2 for Module Options while viewing ANN-BUS Address Screen when the ANN-LED
option is selected, will display the following screen:
ZONES
ALARM, TRBL, SUPV
1=POINT/ZONE
2=ALARM/ATS
3=RANGE
The first screen indicates that the ANN-LED at the selected ANN-BUS address is programmed
to annunciate Alarms, Troubles and Supervisories for Zones 00 through 09. The programming
can be changed using ANN-LED Address Screen 2.
Pressing 1 while viewing ANN-LED Address Screen #2 will program the annunciator module
to annunciate either Point (addressable device address) information or Zone information. Each
press of the 1 key will toggle the display between Point and Zone.
Pressing 2 while viewing ANN-LED Address Screen #2 will program the annunciator module
to annunciate only Alarms or Alarms, Troubles and Supervisories (ATS). Each press of the 2
key will toggle the display between Alarms and ATS.
Pressing 3 while viewing ANN-LED Address Screen #2 will select the Point or Zone range to
be annunciated (refer to the tables in "ANN-RLED Zone Option - Alarm Only" on page 111
and "ANN-RLED Point Option - Alarm Only" on page 113). Pressing the 3 key will display an
additional screen where the range can be selected.
•
If Zone has been selected, and Alarms Only are to be annunciated, the 3 key will have no
effect since all zones can be displayed on only one ANN-LED module.
•
If Zone has been selected, and Alarms, Troubles and Supervisories are to be annunciated, the
new screen will give the options of annunciating Zone 0 - 9 or 10 - 19. Two ANN-LED
modules are required to annunciate all zones in this configuration.
•
If Points has been selected, and Alarms Only are to be annunciated, the new screen will give
the options of annunciating Points 1 - 30 and 31 - 50. Two ANN-LED modules are required
to annunciate all points in this configuration.
•
If Point has been selected, and Alarms, Troubles and Supervisories are to be annunciated, the
new screens will give the options of annunciating Points 1 - 10, 11 - 20, 21 - 30, 31 - 40 or 41
- 50. Five ANN-LED modules are required to annunciate all points in this configuration.
ANN-LED ADDR #
00-09
ANN-LED Address Screen #1
ANN-LED ADDR #
ZN00-09
ANN-LED Address Screen #2
ZONE
ATS
MS-9050UD PN 52413:C 01/23/08