Four-Bay Lff Hot-Plug Drive Backplane - HP ProLiant DL60 Gen9 Maintenance And Service Manual

Remove the non-hot-plug drive backplane.
7.
To replace the component, reverse the removal procedure.

Four-bay LFF hot-plug drive backplane

To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend ("Extend the server from the
3.
page 27) the server from the rack.
Remove the access panel
4.
Remove all hot-plug hard drives.
5.
Disconnect all cables connected to the drive backplane.
6.
rack" on page 27) or remove
("Access panel" on page 33).
("Remove the server from the
Removal and replacement procedures 35
rack" on