Flexiblelom Riser Assembly - HP ProLiant DL60 Gen9 Maintenance And Service Manual

Remove the server from the rack (on page 27).
o
Remove the access panel
4.
Disconnect all cables connected to existing expansion boards.
5.
Remove the PCI riser cage (on page 28).
6.
Remove any existing expansion board from the riser board.
7.
Remove the riser board from the cage.
8.
To replace the component, reverse the removal procedure.

FlexibleLOM riser assembly

To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
("Access panel" on page 33).
Removal and replacement procedures 56