Four-Bay Lff Non-Hot-Plug Drive Backplane - HP ProLiant DL60 Gen9 Maintenance And Service Manual

If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.
To replace the component, reverse the removal procedure.

Four-bay LFF non-hot-plug drive backplane

To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Extend ("Extend the server from the
3.
page 27) the server from the rack.
Remove the access panel
4.
Remove all non-hot-plug drives.
5.
Disconnect all cables connected to the drive backplane.
6.
rack" on page 27) or remove
("Access panel" on page 33).
("Remove the server from the
Removal and replacement procedures 34
rack" on