CAUTION:
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 28).
o
Remove the server from the rack (on page 29).
o
Open the access panel latch, slide the access panel to the rear of the chassis, and then remove the
4.
access panel.
If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.
To replace the component, reverse the removal procedure.
Four-bay LFF hot-plug drive backplane
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 28).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Do not operate the server for long periods with the access panel open or removed.
("Access
panel" on page 30).
Removal and replacement procedures 31