Processor - HP ProLiant DL60 Gen9 Maintenance And Service Manual

Remove the screws, then remove the processor blank.
5.
To replace the component, reverse the removal procedure.

Processor

The server supports single-processor and dual-processor operations.
WARNING:
internal system components to cool before touching them.
CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
configurations must contain processors with the same part number.
CAUTION:
processor and a heatsink or a processor socket cover and a processor blank.
IMPORTANT:
In a multiprocessor configuration, to optimize system performance, HP recommends balancing the total
capacity of the DIMMs across the processors.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To avoid damage to the processor and system board, only authorized personnel
To prevent possible server malfunction and damage to the equipment, multiprocessor
To prevent possible server overheating, always populate processor socket 2 with a
Processor socket 1 must be populated at all times or the server does not function.
Removal and replacement procedures 47