Hot-Plug Drive; Four-Bay Lff Hot-Plug Drive Backplane Assembly - HP ProLiant ML30 Gen9 Maintenance And Service Manual

Hot-plug SFF drive blank
o
To replace the SFF drive blank, while pressing the release latch, slide the component into the bay until it
is fully seated.

Hot-plug drive

CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
Back up all server data on the drive.
1.
Remove the bezel
2.
Determine the status of the drive from the drive LED definitions
3.
page 76).
Remove the hot-plug drive.
4.
Hot-plug LFF/SFF drive
o
To replace the component, reverse the removal procedure.

Four-bay LFF hot-plug drive backplane assembly

("Unlock and remove the bezel" on page 26).
("Hot-plug drive LED
Removal and replacement procedures 30
definitions" on