Front I/O Module - HP ProLiant DL60 Gen9 Maintenance And Service Manual

To replace the component:
Insert the battery with the "+" side facing up underneath the outer lip of the socket, and then press the
1.
battery down to secure it in place.
Install any expansion boards that have been removed.
2.
Install the access panel.
3.
Do one of the following:
4.
Slide the server into the rack.
o
Install the server into the rack.
o
Power up the server.
5.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.

Front I/O module

To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 27).
o
Remove the access panel
4.
Release the front I/O cabling from the server:
5.
Detach the ambient thermal sensor cable from its clip.
a.
Release the ambient thermal sensor cable from the front chassis cable clip.
b.
Disconnect the front I/O module cable.
c.
("Access panel" on page 33).
Removal and replacement procedures 59