Optical Drive - HP ProLiant DL60 Gen9 Maintenance And Service Manual

Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 27).
o
If installed, remove the security bezel
4.
Remove the access panel
5.
Remove the optical drive blank
6.
To replace the component, reverse the removal procedure.

Optical drive

CAUTION:
all bays are populated with a component or a blank.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 27).
o
If installed, remove the security bezel
4.
Remove the access panel
5.
("Remove the security bezel
("Access panel" on page 33).
To prevent improper cooling and thermal damage, do not operate the chassis unless
("Remove the security bezel
("Access panel" on page 33).
(optional)" on page 26).
(optional)" on page 26).
Removal and replacement procedures 39