Table of Contents
Advertisement
PSU status indicator (1)
Status
flashing green
green on
flashing amber
amber on
17.2.4
Acoustic indicators
PEI Beep Codes
Pre-EFI Initialization (PEI) - memory Initialization (bootblock)
# of
Description
Beep
1
Memory not installed
2
Recovery started
4
Recovery failed
DXE Beep Codes
Driver Execution Environment (DXE) - main hardware Initialization (POST)
GX2570 M6
Description
The server is switched off, but mains voltage is present
(standby mode).
The server is switched on and operating properly.
An overload has been detected. The PSU is still running,
but failure might be imminent.
A PSU failure has been detected.
Action
▶ Check if the memory module is
▶ Check if the memory module is
Recovery procedure is initialized by
jumper settings on the system board and
announced with two beep.
This is only an information.
▶ Restart the recovery procedure again.
▶ If the same beep code sounds again,
Upgrade and Maintenance Manual
installed.
installed correctly.
replace the system board.
Appendix A
269
Advertisement
Table of Contents
