Acoustic Indicators - Fujitsu PRIMERGY TX1320 M4 Upgrade And Maintenance Manual

15.2.4 Acoustic indicators

PEI Beep Codes
Pre-EFI Initialization (PEI) - memory Initialization (bootblock)
# of Description
Beep
1 Memory not installed
2 Recovery started
4 Recovery failed
DXE Beep Codes
Driver Execution Environment (DXE) - main hardware Initialization (POST)
# of Description
Beep
1 Invalid password
5 No Console Input
devices1 or Output
devices2 are found
TX1320 M4
Action
Ê Check if the memory module is installed.
Ê Check if the memory module is installed
correctly.
Recovery procedure is initialized by jumper
settings on the system board and announced
with two beep.
This is only an information.
Ê Restart the recovery procedure again.
Ê If the same beep code sounds again,
replace the system board.
Action
Ê Check for the correct password and try
again.
Ensure that the caps lock key is
deactivated.
Booting will continue.
1 Serial console redirection is considered a
console output device if enabled.
2 Serial console redirection is considered a
console input device if enabled.
This beep code is only an information.
Upgrade and Maintenance Manual
Appendix A
335