Solid-State Drive - HP EliteBook 845 Maintenance And Service Manual

3. Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
remove the module (2). Use the same procedure to remove all memory modules.
To install a memory module, reverse the removal procedure.
NOTE: Memory modules are designed with a notch to prevent incorrect insertion.

Solid-state drive

To remove the solid-state drive, use this procedure and illustration.
Table 5-5 Solid-state drive descriptions and part numbers
Description
2 TB, M.2 2280, PCIe-4×4, ZTurbo solid-state drive with TLC
1 TB, 2280, PCIe-4×4, NVMe solid-state drive with TLC
512 GB, M.2 2280, PCIe-4×4, SED solid-state drive with TLC
512 GB, M.2 2280, PCIe, NVMe, value solid-state drive
512 GB, 2280, PCIe-4×4, NVMe solid-state drive with TLC
256 GB, M.2 2280, PCIe-4×4, ZTurbo solid-state drive with TLC
256 GB, M.2 2280, PCIe-4×4, SED solid-state drive with TLC
256 GB, M.2 2280, PCIe, NVMe, value solid-state drive
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page 39).
39).
Battery on page 41).
Spare part number
M52027-001
M16560-001
M52031-001
M85364-001
M17436-001
M52025-001
M52029-001
M85354-001