HP EliteBook 845 Maintenance And Service Manual page 69

h. Remove the webcam module.
The webcam module is available using spare part numbers N17325-001 (for use on computer models
equipped with an infrared webcam module) and N17324-001 (for use on computer models equipped
with an RGB webcam module).
17. If you need to remove the hub board:
a. Remove the display assembly.
b. Remove the display bezel.
c. Remove the hinge cover.
d. Remove the hinges.
e. Remove the display panel.
f. Release the ZIF connector (1) to which the webcam module cable is connected, and then disconnect
the webcam module cable from the hub board.
g. Release the ZIF connector (2) to which the ALS sensor board cable is connected, and then disconnect
the ALS sensor board cable from the hub board.
h. Release the ZIF connector (3) to which the hub board cable is connected, and then disconnect the hub
board cable from the hub board.
i. Release the ZIF connector (4) to which the microphone module cable is connected, and then
disconnect the microphone cable from the hub board.
j. Detach the hub board (5) from the display assembly. (The hub board is attached to the display
assembly with double-sided adhesive.)
k. Remove the hub board.
The hub board is available using spare part numbers N17325-001 (for use on computer models
equipped with an infrared webcam camera) and N17324-001 (for use on computer models equipped
with an RGB webcam camera).
18. If you need to remove the WLAN antennas:
Display assembly 63