Fingerprint Reader - HP EliteBook 845 Maintenance And Service Manual

2. Detach the NFC module antenna (2) from the top cover/keyboard and touchpad. (The NFC module antenna
is attached to the top cover/keyboard and touchpad with double-sided adhesive.)
3. Remove the eight Phillips M1.5 × 2.2 screws (3) that secure the touchpad to the computer.
4. Remove the touchpad (4) from the computer.
To install the touchpad, reverse the removal procedure.

Fingerprint reader

To remove the fingerprint reader, use this procedure and illustration.
Table 5-13 Fingerprint reader description and part number
Description
Fingerprint reader
NOTE: The fingerprint reader spare part kit does not include the fingerprint reader bracket or the fingerprint
reader cable. The fingerprint reader bracket is included in the Braclet Kit, spare part number N13682-001. The
fingerprint reader cable is included in the Cable Kit, spare part number N18760-001.
Before removing the fingerprint reader, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the right speaker (see
Remove the fingerprint reader:
1. Release the ZIF connector (1) to which the fingerprint reader cable is connected, and then disconnect the
fingerprint reader cable from the system board.
2. Detach the fingerprint reader cable (2) from the top cover/keyboard. (The fingerprint reader cable is
attached to the top cover/keyboard with double-sided adhesive.)
Preparation for disassembly on page
Bottom cover on page
Battery on page 41).
Speakers on page 49).
39).
Spare part number
N02325-001
39).
Fingerprint reader 71