Triumph Street Triple S Owner's Handbook Manual page 35

Daytime Running Lights (DRL) (if
fitted)
When the ignition is switched
ON and the daytime running lights
switch is set to Daytime Running Lights,
the daytime running lights warning light
will illuminate. During daylight hours, the
Daytime Running Lights (DRL) improve
the visibility of the motorcycle to other
road users. Low beam headlights must
be used in any other conditions unless
the road conditions allow for high beam
headlights to be used.
The daytime running lights and low
beam headlights are operated manually
using a switch on the left hand switch
housing, see page 35.
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the Daytime Running
Lights when dark, in tunnels or where
poor ambient light is apparent may
reduce the riders vision or dazzle
other road users.
Dazzling other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control
and an accident.
GENERAL INFORMATION
High Beam Button
If the Daytime Running Light (DRL)
switch is in the dip beam position, when
the High Beam button is operated then
the high beam will be switched on. Each
press of the button will swap between
dip and high beam.
If the DRL switch is in the daytime
running lights position, then press and
hold the High Beam button to turn the
high beam on. It will remain on as long
as the button is held in and will turn off
as soon as the button is released.
Note
A lighting on/off switch is not fitted to
this model. The position light, rear light
and licence plate light all function
automatically when
turned to the ON position.
The headlight will function when the
ignition switch is turned to the ON
position.
the ignition is
35