Triumph Street Triple S Owner's Handbook Manual page 104

GENERAL INFORMATION
104
▼ Once the ABS, MAP and TTC settings
have changed, the selected riding
mode will be shown and the previous
mode will no longer be shown.
▼ Resume riding as normal.
▼ If any one of the systems (ABS, MAP
and TTC) fails to change to the
settings specified by the selected
riding mode, both the previous and
the selected riding mode icons will
flash.
1. Incomplete mode change (flashing)
▼ The flashing of two riding mode icons
together indicates that ABS, MAP
and TTC settings specified by the
selected riding mode have not been
correctly selected. In this case the
ABS, MIL or TTC warning light(s) may
be illuminated depending on the
current state of each system.
In the event of an incomplete riding
mode change:
▼ Safely bring the motorcycle to a stop.
▼ Select Neutral.
▼ Turn the ignition OFF and then back
ON again.
▼ Select the required riding mode.
▼ Restart the engine and continue
riding.
1
Note
If the mode icons are not shown when
the ignition switch is in the ON position,
make sure that the engine stop switch
is in the RUN position.
Warning
Do not stop the engine using the
ignition switch or engine stop switch
whilst the motorcycle is moving.
Always bring the motorcycle to a stop
safely and engage Neutral gear prior
to stopping the engine.
Stopping the engine by turning off the
ignition or engine stop switch whilst
the motorcycle is moving can lock the
rear wheel causing loss of motorcycle
control and an accident.
Caution
The engine should
stopped by turning the ignition switch
to the OFF position.
The engine stop
emergency use only.
Do not leave the ignition switched on
with the engine stopped. Electrical
damage may result.
Caution
The engine should not be stopped by
turning the ignition switch to the OFF
position when the
moving. The engine stop switch is for
emergency use only.
Stopping the engine
motorcycle is moving
damage to motorcycle components.
normally be
switch is for
motorcycle is
when the
may cause