Preparation after Storage
To prepare the motorcycle to be ridden
after storage, do the following:
▼ Install the battery (if removed) (see
page 189).
▼ If the motorcycle has been stored for
more than four months, change the
engine oil (see page 147).
▼ Check all the points listed in the Daily
Safety Checks section.
▼ Before starting the engine, remove
the spark plugs from each cylinder.
▼ Put the side stand down.
▼ Crank the engine on the starter
motor several times.
▼ Refit the spark plugs, tightening to 12
Nm, and start the engine.
CLEANING AND STORAGE
▼ Check and if necessary correct the
tyre pressures (see the relevant
Specification section).
▼ Clean the entire vehicle thoroughly.
▼ Check
the
operation.
▼ Test ride the motorcycle at low
speeds.
brakes
for
correct
205