Locations And Functions Of Parts And Controls; Power Source; Attaching The Battery Pack - Sony JumboTron JME-SA200 Service Manual

Locations and Functions of Parts and Controls

Front panel
8
1
9
!º
2
3
4
5
6
7
1 EJECT (card eject) button (inside)
To eject the digital data card, press the EJECT button
inside the unit using the supplied eject tool.
2 PC CARD (digital data card) slot
Insert the digital data card.
3 LCD display window
4 Function buttons (F1 – F5)
The functions of the buttons change with the stage of
the operation. The current functions are indicated at
the bottom of the display window.
For details, see each section.
5 MENU button
Returns to the upper directory of the menu.
6 CURSOR v/V/B/b buttons
Select the menu items in the display window or change
the set values.
7 ENTER button
Confirms the selected item and stores the set value.
6 CONTROL connector (D-sub 15-pin)
Connect to the CONTROL 2 connector of the JTC-
C200 ICU controller for wired control.
10
Locations and Functions of Parts and Controls Overview
Rear panel
!¡
!™
!£
!¢
!¡
9 LCD DISPLAY switch
Turns on/off the backlight of the LCD display window.
The battery life will be longer if the backlight is turned
off.
0 Connector guard
Note
Use a connector whose size is smaller than the
connector guard.
!¡ Shoulder strap attachments
Attach the supplied shoulder strap here. Two sets of
the attachments are provided at the top and bottom of
the unit.
!™ POWER switch
Turns the unit on/off.
!£ Battery pack compartment
Attach the NP-F750 rechargeable battery pack (not
supplied) here.
!¢ BATT EJECT (battery eject) lever
Press this lever downward to unlock the battery pack
and remove it.

Power Source

The NP-F750 rechargeable battery pack (not supplied) is used for the
power source of this unit.
Before attaching the battery pack, charge it using the AC-V615 AC power
adaptor (not supplied).
For charging and details of the use of the battery pack, refer to the Operating
Instructions supplied with the rechargeable battery pack and the AC power
adaptor.

Attaching the battery pack

Attach the battery pack to the battery pack compartment on the rear of the
unit.
Insert the battery pack as shown and slide it in the direction of the arrow.
The battery pack is locked in position.
Note
After attaching, confirm that the battery pack is locked firmly. If the
battery pack is not locked, it may fall during operation and the adjustment
data may be lost.
Battery charging time
When charging the exhausted battery pack using the AC-V615 AC power
adaptor, the following charging time is required.
Normal charging time: Approx. 3 hours 30 minutes
Full charging time: Approx. 4 hours 30 minutes
The normal charging time is the time until the charging lamp on the AC
power adaptor goes out. The full charging time is the time until the battery
pack is fully charged, giving a longer battery life.
Battery life
When the fully charged battery back is used continuously under normal
temperatures, the following battery life is obtained.
When the LCD display window is backlighted: Approx. 3 hours
When the backlight is turned off: Approx. 3 hours 10 minutes
The battery life may vary depending on the ambient temperature or the
battery condition.
Check the direction
of the " mark.
11
Power Source and Connections Overview