Table of Contents
Advertisement
Names and Functions of Parts
Output selection section
2 VIDEO gain switch
1 RESET button
3 TO VTR connector
1 RESET button
This resets the internal CPU to the same initial state as
after powering on. If the system stops operating
normally, press this button using a ball-point pen or
similar. Pressing this button does not affect settings
saved in the internal memory.
2 VIDEO gain switch
Toggles the lower limit of the adjustment range for the
master gain adjustment knob and level adjustment
knobs between –∞ and –3 dB. The factory default
setting is –∞.
Memory section
Level adjustment section
3 TO VTR connector (D-sub, 15-pin)
Connect to the VIDEO CONTROL connector of the
HDW-500 or the VIDEO CONTROL connector of a
PFV-series. For the connection, use an optional RCC-
1502H/1505H/1510H/1530H remote control cable.
3
Advertisement
Table of Contents
