Table of Contents
Advertisement
Connections
Connections for using as wired controller
The unit can be used as a wired remote controller by connecting to the
JTC-C200 ICU controller. The connecting cable can be extended up to
1,000 m.
Connecting diagram
CONTROL
D-sub 15-pin
JME-SA200
Note
Use a connector whose size is smaller than the connector guard.
16
Power Source and Connections
Overview
JTC-C200 ICU controller
CONTROL 2
D-sub 15-pin
Registering the Phone Number for the Modem
Register the phone number for the modem connected to the ICU controller
to this unit. Once it is registered, the unit automatically starts dialing when
the power is turned on.
MENU button
v/V/B/b buttons
1
Turn off the power of the cellular phone.
If the cellular phone is turned on, the unit will automatically start
dialing when the phone number registration is completed.
2
Set the POWER switch of the unit ON.
The title display appears in the display window.
J U M B O T R O N
M A I N T E N A N C E E Q U I P M E N T
J M E - S A 2 0 0
3
Hold down the B button until the PHONE NUMBER display appears.
* * * * P H O N E N U M B E R * * * *
P H O N E N U M B E R :
X
1
2
ENTER button
POWER switch
Cursor
3
4
5
(continued)
17
Power Source and Connections
Adjustment
Advertisement
Table of Contents
