If Connected With Ethernet Cables; Setting Up The Servo Amplifier Connected To The Gm1 Controller - Panasonic GM1 Series User Manual

11.1 Setting up the Servo Amplifier Connected to the GM1 Controller

11.1 Setting up the Servo Amplifier Connected to the GM1 Controller
This section explains how to set up MINAS series servo amplifiers connected to the GM1
Controller.
For other devices, refer to their instruction manuals when setting up them.
The PC communicates with the servo amplifier connected to the GM1 Controller.
Connect the PC and GM1 Controller with an Ethernet cable or USB cable. With the GM1
Controller and servo amplifier connected with a Cat5e shielded cable, set up the servo
amplifier.
● Perform this setup work only after the connection between the GM1 Controller and the
servo amplifier has been established.

11.1.1 If Connected with Ethernet Cables

If connected with Ethernet cables, use the following procedure.
1.
Start PANATERM Lite for GM.
The "Connect" dialog box will be displayed.
2.
Select "Connect to the GM series controller with LAN" and click the [OK] button.
The "Communication timeout settings" dialog box will be displayed.
11-2 WUME-GM1ETCSU-01