Table of Contents
Advertisement
Starting
Check before Starting System
Be sure to check the following items before starting the S-LINK V system or before turning on the power:
• Wiring conditions of the controller
• Shorted cables
SL-VGU1-C wiring condition check
Visually check the terminals of the SL-VGU1-C and the connected cable (terminals to which the cable is con-
nected).
S-LINK V terminal block connector side
No.
Designation
8
ERR
7
G
6
D
Main line
5
0V
4
24V
3
0V
Input
2
24V
1
FG
Power-on (Main Power and Local Power)
CAUTION
● To use both the main power and the local power, be sure to turn on the local power first or turn on
both powers at the same time.
● To turn on the power for the first time after system installation, set the mode selection switch to
'CONFIG,' and then turn on the power.
At the completion of check before starting the system, turn on the power.
The S-LINK V system will be activated.
CONFIG Mode
In the CONFIG mode, the displayed items depend on the CONFIG mode selection timing.
● If the system is switched to the CONFIG mode before power-on:
Each item can be set.
● If the system is switched to the CONFIG mode after power-on:
Difference from the above-described case (CONFIG mode selection before power-on) is the following three
points:
• The default items will not be displayed.
• The preset items will not be displayed.
• The set value of each item is displayed, but changing the set value will not be possible.
For a detailed description of various settings for CONFIG mode and the set modes, refer to page 48 and fol-
lowing pages.
48
Wire color / Description
Error output
Black
White
Blue
Brown
External power supply input
Frame ground
CC-Link terminal block connector side
No.
Designation
8
DA
Comprised of two terminals for cascade wiring.
7
6
DB
Comprised of two terminals for cascade wiring.
5
4
DG
Comprised of two terminals for cascade wiring.
3
2
Connect the shielded wire of the CC-Link cable
S
to one terminal, and ground the other terminal.
1
Description
Advertisement
Table of Contents
