Select the "Configured station alias" option and enter the setting of the rotary switch on the
front panel of the servo amplifier and the setting of Pr7.40 into the input field.
Example: When the value of the rotary switch on the front panel of the servo amplifier is
set to 8 and the value of Pr7.40 is set to 1
The high-order 8 bits and low-order 8 bits represent 1 and 8, respectively. Therefore, enter
264 in the input field.
Station alias
High-order 8 bits Low-order 8 bits
3740H setting
● When Pr.7.41 is set to 1
Select the "Disable" option.
The numerical value displayed in "EtherCAT address" is set as the station alias value.
WUME-GM1ETCSU-01
10.5 Adding and Setting up Servo Amplifiers
Rotary switch setting
10-13